SAMSUNG PROJECTION TV [NO POWER] HLP4663W/5063W/5663W/6163W
THE UNIT WILL NOT POWER ON [SAMSUNG - HLP4663W/5063W/5663W & 6163W
THE TIMER, LAMP AND STANDBY / TEMP FRONT LEDs ARE FLASHIG
There has been a common problem found with the Ballast Assembly
to the above said models. So, there were two modifications made to the
Ballast to improve reliability. The modification include addition of
two capacitors to the Ballast board, and the shortening of the ballast
cables from 230mm to 130mm.
Replace the Ballast PCB if the unit you have falls within the serial number ranges, listed for this problem.
BALLAST USED: BP96-00690A.
The new Ballast will be provided as an assembly with plastic base.
- Serial Number Range:
- 31DX300130 TO 31DX300303
- 31DX400001 TO 31DX402858
ORDERING LIGHT ENGINES
- Contact the customer care center to verify the model code your DLP TV; if it is HLN -WX or W1X models.
- Confirm the Model Code on the sticker attached to the set. On
HLM models, the Model Code will be on the backside sticker of the
cabinet. On models HLN and HLP, the Model Code will be on the sticker
located on the side of the cabinet bezel. - Confirm the Lamp Part number on the sticker located on the lamp door or access way attached to set.
- Once all these confirmation has been verified, beofore place an order to Light Engine.
If a situation is encountered where the Light Engine is
available does not match with the lamp type in the unit, the lamp type
selection in service mode have to be adjusted before completing the
repair work.
For example, if the Unit originally has an OSRAM light Engine.
The only available replacement is PHILIPS type Light Engine.
Remote control Service Mode Entry:
Put the set in standby mode.
Press [MUTE+1+8+2+POWER]
Enter either DDP1010 or DDP1011 Service Menu.
Select and adjust the Lamp Parameter to match the Lamp Type of new Light Engine.
No comments:
Post a Comment