40PFL6606-D - PHILIPS LCD TV - SSB

REPLACEMENT - Adjustments - SET

STARTS UP IN FACTORY MODE

RESET OF REPAIRED SSB [Small Signal Board]

A very important issue towards a repaired SSB from a Service repair
shop (SSB repair on component level) implies the reset of the NVM on the SSB.

A repaired SSB in Service should get the service Set type
“00PF0000000000” and Production code “00000000000000”. Also the virgin bit is to be set. To set all
this, you can use the ComPair tool or use the “NVM editor” and “Dealer options”
items in SAM (do not forget to “store”)

After a repaired SSB has been mounted in the set (set repair on board level), the type number (CTN) and
production code of the TV has to be set according to the type plate of the set.
For this, you can use the NVM editor in SAM. This action also ensures the
correct functioning of the “Net TV” feature and access to the Net TV portals.
The loading of the CTN and production code can also be done via ComPair (Model
number programming).

After a SSB repair, the original channel map can be restored, provided
that the original channel map was stored on a USB stick before repair was
commenced and that basic functionality of the TV, needed for this procedure,
was not hampered as a result of the defect. The procedure of “channel map
cloning” is clearly described in the (electronic) user manual.

In case of a display replacement, reset the “Operation hours display”
to “0”, or to the operation hours of the replacement display.

SSB identification

Whenever ordering a new SSB, it should be noted that the correct
ordering number (12nc) of a SSB is located on a sticker on the SSB. The format
is <12nc SSB><serial number>. The ordering number of a “Service”
SSB is the same as the ordering number of an initial “factory” SSB.

Instructions flowchart in case a SSB has to be exchanged. Instruction note SSB replacement Q543.x,
Q548.x, Q549.x, and Q55x.x

Before starting:

> prepare a USB memory stick with the latest software

> download the latest Main Software (Fus) from www.p4c.philips.com

> unzip this file

> create a folder ”upgrades” in the root of a USB stick (size >
50 MB) and save the autorun.upg file in this "upgrades" folder.

Note: it is possible to rename this file, e.g."Q54x_SW_version.upg";
this in case there are more than one "autorun.upg" files on the USB
stick.

Due to a possible wrong display option code in the received Service SSB
(NVM), it’s possible that no picture is displayed. Due to this the download
application will not be shown either. This tree enables you to load the main
software step-by-step via the UART logging on the PC (this for visual
feedback).